Im starting to get into more serious setup and I got this 96V controller. It uses these ring terminals.
I had a couple of questions.
I dont have a vice or a crimping tool and the metal is too thick to crimp the wires by hand. Hammer maybe? Or safer ideas haha
I noticed that when I scuffed up the terminls, silver paint came off and revealed im guessing copper?
Is it a good idea to sand down the terminlas to get better contact?
Thanks in advance
https://ibb.co/0rpbbYJ
https://ibb.co/mttLrG3
https://ibb.co/9qj41tw
I had a couple of questions.
I dont have a vice or a crimping tool and the metal is too thick to crimp the wires by hand. Hammer maybe? Or safer ideas haha
I noticed that when I scuffed up the terminls, silver paint came off and revealed im guessing copper?
Is it a good idea to sand down the terminlas to get better contact?
Thanks in advance
https://ibb.co/0rpbbYJ
https://ibb.co/mttLrG3
https://ibb.co/9qj41tw