Oset 20r Low Voltage Cuttoff Needed!

Jonboy

Jonboy

1 kW
Joined
Aug 18, 2013
Messages
318
Location
S. Wales
Hi Guys as title.. I'm converting my lads oset 20r 48v to Lipo via 6no. packs of 6s1p turnigy 5ah set up as 12s3p. I was just going to relay on watching a digital voltmeter on the bars and simply stop when volts dropped to 44v at rest but I think I best try and source a LVC device as a safegaurd.
So anybody know of such a device I could use? Shame the oset controller doesn't have connectivity to a cycle analyst :cry:

Look forward to any replies!!


Thanks

Jon
 
If you want to do it at cell level then you can either get a bms or improvise with a couple of lv cell meters from hk. For total pack lvc you could use a CA as its possible to rig it up to nearly any controller or if you are handy with electronics you could put something together as in this thread http://endless-sphere.com/forums/viewtopic.php?f=2&t=61407 for a cost for parts of around £20 + time. Other than that I dont know of any off the shelf aftermarket lvc's.
 
You must log in or register to reply here.
Back
Top