nonlineartom
1 kW
I've got this 6T mac with a suspected dead hall. I've got the side case off and I can see the halls are mounted onto a PCB and the hall sensors themselves are epoxyed into the gaps in the stator. I've got a replacement whole PCB on order compelte with halls soldered in so now all that remains is get the old ones out of there. Whats the best method for getting that epoxy bond loosened off whilst causing as little damage as posible to the motor itself?
Dremel?
Freeze it?
Heat it?
answers on the back of a postcard
Dremel?
Freeze it?
Heat it?
answers on the back of a postcard