Recent content by mdan

Jerry pic of your sprocket side, how did you get the gears to work with the derailler setup? I want to add the gears but cant figure out the setup, what did you use etc. thanks, Mike what volts are you running? I am running 48 volts with a lyen controller.

how did you guys add the extra gears so you can peddle it? I have a bmc rear geared hub running on the smallest sprocket on the 7 speed cassette, and its a bear to peddle around. but its a good workout too. any pic's of the rear sprocket setup? thanks, mike

its your phase wires, I had the same situation, have the same motor too. Ed sent me the phase wire schematics for his controller etc. once the right combo was set, the motor was good to go. Ask him to send you his wiring schematics for the motor. He runs one or two of the same exact motors...

did you buy the crystalyte controller too? I recently switched over to the bmc 1500 with a lyens 4100 controller. I am running it off 14 tooth / 110 tooth on the left side, single reduction belt drive. I used a fixed pulley on the disc brake side, so I only have the front avid disc. I will...

I recently upgraded to a brushless 1500 watt superkids motor, running a 36 volts at 20 lipo4 fox power, using a lyens 4100 controller. Single reduction at 14/110 using 24 inch wheels etc. Coming off a brushed 1000 watt currie motor with a 36 volt 25 amp chinese controller, everything else the...

can you email me a price? what is the output shaft diameter? thanks, Mike

I have been running a belt drive / belt drive for the last year or so with 800 watt brushed motor, before it was a ice set up, using belt drive/ belt drive. I need to post pictures of my bike with the single reduction 14 tooth to 110 tooth rear sprocket. I posted earlier about using matt's...

After years of riding my bikes as ice, I updated to an 800 watt brushed motor, tnc controller, 24-48 volts sla battery setup. For the last year or so, it has never failed me, yet the weight of the 48 volts sla are cumbersome, to where I actually ride it at 24 volts, 18-20 miles per hr. first...

this is the front hub motor your selling? does it come with the matching controller? how much for the setup minus batteries? do you think it would be better to just buy the kit like yourself.? thanks, Mike