Thank you for the links. Can't find replacement buttons on http://www.ebikes.ca/ site, guess I'll email and see if the still sell them.
As to whether my CA has ever been wet, it has. Which in my opinion is a given considering cycling is an outdoors activity. The buttons have however never been...
My cycle analyst 2.3 has stopped responding to button pushes. Few weeks back i noticed upon riding of in the morning that the display was cycling thru the menus as if i was pushing the left most of the 2 buttons repeatedly. I was in a hurry and didn't think much of it and just continued my...
I have searched, high and low. Can't find anyone modding a unit with the same circuit board. My intention was doing what's been done and proven. Getting this bastard of a unit was just a careless mistake on my part. Without modification its pushing 9 amps at 48.5V. I don't think it would survive...
Hello. Bought a PSU with the intent of doing the modifications in this link:
http://www.recumbents.com/wisil/e-bent/meanwell/default.htm
However i didn't pay close enough attention and managed to buy a slightly different model. Namely the "S360-48" instead of "S350-48". I'm still looking to do...
If the fast remark is regarding the shipping speed I agree, your probably right. Other than that I haven't addressed speed. But now that its brought up, 45-50km/h is my ideal speed.
Ps thanks for wishing me good luck, i recon I'm way overdue for some luck in the ebike field!
Caught me posting, Thanks for the red flag. Think i saw 3-5 day shipping stated on their site, not that it would be the first time a vendor is sketchy on delivery dates.
I agree with all you've said Punx0r, just want to clarify, in case my first post was unclear. I'm not set on either of the two, their just the best deal i found so far. All suggestions are welcome and sought after!
Hello guy, I've gotten myself in a pinch, In two weeks I will begin commuting longer than i care to pedal. And the pinch? Well my current setup is all bogged down and i need a replacement.
The objective: I need to score a new motor!
Conditions:
-Must be at my doorstep in less than 2 week...
Hello all. I changed the phase wires on a MAC 8t but foolishly dident mark them, so now i don't know which phase wire is which. What is the easiest way to determine which phase is which? so i can connect it properly to my controller.
Thank you! I tried using the grin simulator earlier today, but messed up when entering the battery internal resistant. Couldn't get it to plot anything. Your elaborate example cleared that right up. Much appreciate the effort you put in to helping!
Hijacking is hereby over!
That's understandable, how about a request?
System A: 26" wheel, 12s Lipo, Limited to 35A
System B: 24" wheel, 12s Lipo, Limited to 35A
System C: 24" wheel, 18s Lipo, Limited to 25A
Sorry about the hijacking!