olaf-lampe
10 kW
The motor seems to run with wrong timing. But at least, it seems you've found the right firing order.
Label the hall signal cables in the connector like 1-2-3;
then put cable 1 in position 2; 2 in position 3; 3 in position 1. ( position in the connector )
If that doesn't work; put 1 in position 3; 2 in position 1 and 3 in position 2.
If that doesn't work too, you connect the signal cables as they were originally and put the hall sensors in the neighbour stator-slots. Then try again, what I described above.
When the motor runs the wrong way round, you have to exchange two phase wires and the corresponding hall wires. The motor will also run in a different direction, when you try out one of the above mentioned hall-wire placements.
Good luck
Olaf
Label the hall signal cables in the connector like 1-2-3;
then put cable 1 in position 2; 2 in position 3; 3 in position 1. ( position in the connector )
If that doesn't work; put 1 in position 3; 2 in position 1 and 3 in position 2.
If that doesn't work too, you connect the signal cables as they were originally and put the hall sensors in the neighbour stator-slots. Then try again, what I described above.
When the motor runs the wrong way round, you have to exchange two phase wires and the corresponding hall wires. The motor will also run in a different direction, when you try out one of the above mentioned hall-wire placements.
Good luck
Olaf