icecube57
10 MW
Ive been trying to address a way to reach out to thehigh current and high performace crowd with my harness service while making my job easier. Im was trying to gauge how you guys felt about mechanical crimping. I found some 8G mechancial crimp splices. I figure it could take 4 12g or 10g on one side and one 8G on the other. These are technically used in fence building but i figure i could flux and solder to make a better connectionand then cover the entire joint with about two layers of heat shrink.
Here is a video that kinda explains what Im talking about..
[youtube]EYI4UpODxKU[/youtube]
Here is a video that kinda explains what Im talking about..
[youtube]EYI4UpODxKU[/youtube]