hrottier
1 µW
Greetings:
I am wondering if anyone could advise me on how to wire my bionx hub motor after removing the controller. I have read some links here on using an external controller with this hub and so I decided to take mine apart. So after opening the hub motor I am faced with several questions. There are two black wires that go to the winding and 2 red wires that go to the windings and several white wires. I am assuming the two black wires along with the black lead that comes into the hub get tied together and the same for the red wires. I am not sure how to deal with the white wires. I am also confused by how to reconnect the hall sensors.
I also have a question about the 22 magnets and there configuration. In my eagerness, I did not mark them when I took them out to clean. Does anyone know their sequence as to putting them back in. Would it be positive/negative/positive/negative, or perhaps 2 positive/2 negative/ 2 positive/2negative.
I would appreciate any help given.
Harold
I am wondering if anyone could advise me on how to wire my bionx hub motor after removing the controller. I have read some links here on using an external controller with this hub and so I decided to take mine apart. So after opening the hub motor I am faced with several questions. There are two black wires that go to the winding and 2 red wires that go to the windings and several white wires. I am assuming the two black wires along with the black lead that comes into the hub get tied together and the same for the red wires. I am not sure how to deal with the white wires. I am also confused by how to reconnect the hall sensors.
I also have a question about the 22 magnets and there configuration. In my eagerness, I did not mark them when I took them out to clean. Does anyone know their sequence as to putting them back in. Would it be positive/negative/positive/negative, or perhaps 2 positive/2 negative/ 2 positive/2negative.
I would appreciate any help given.
Harold