DriftTrike
1 mW
- Joined
- Sep 5, 2016
- Messages
- 16
It's definitely not enough. Unfortunately I can't go much larger. I have the new fat bike rear end for the Vector light frames. Artur uses a 38T max with these rear ends. I was trying to figure out how to extend the bottom bracket spindle so I could run a larger toothed front crank but its not an easy task. The bottom bracket measures 100mm and the spindle is 164mm. Finding a spindle that will fit has been incredibly difficult. I've also considered replacing the entire bottom bracket but I haven't found any options that give a large enough spindle width in a 100mm bottom bracket shell size.
For the time being, my plan is to get the bike running with the 36T and figure out how to upgrade it later.
For the time being, my plan is to get the bike running with the 36T and figure out how to upgrade it later.