Kels74
10 µW
I have a 60v 5600w dual motor laotie ti30 land breaker.I changed from JP controllers to yunli controllers and I got everything hooked up but got motor failure error.so to make long story short I tested the halls from the motor.both motors had a bad hall on the blue sensor.so I completely replaced the entire board with 3 new sensors.hooked up the tester again and the same hall shows bad.what is going on guys.its one thing to have the same sensor go bad at the same time in both motors.but to replace one whole board never even connect it to a controller and the exact same hall shows bad?what's causing this?anyone know?I'm ruling out bad sensors for now.BC thats just too much for me .there's s problem somewhere else.I'm not tefhnician I'm self taught working on my own scooters.doing just this asking those who know better than me.so please if u know explain it for dummy's.lol.thanks.