Hi Ebike gurus
i have a 48V LiFePO4 battery pack with a 20 Amp BMS
which has only one XT60 plug ( +ve red wire and - ve black wire )
for powering the Controller and charging purposes.
i need to disconnect the XT60 plug from the Controller
and than connect it to my Battery charger (5...
Hi
my problem has been solved with the help from GRIN TECHNOLOGIES
internal technical support.
the solution:
-the Crystalyte Controller no. 6 plug ( 6 pin female CycleAnalyst CA )
to the Cycle Analyst V3.1 plug ( 6 pin male ).
-the Thumb Throttle plug ( 3 pin male ) to the Crystalyte...
excuse my error...
So what specifically happens when you set the CA to Bypass mode in the Throttle menu?
in Bypass mode nothing happens ie; hub motor won't spin when thumb throttle is turned
but
the CA Slider bar goes up & down on the main display in response to the thumb throttle being...
ebike gurus
i have the following hardware all connected up
but hub motor will not spin or work
when power is ON & the Thumb throttle is turned.
the THROTTLE SLIDER on the Cycle Analyst
main display can be seen moving up & down
when the Thumb throttle is turned to max & min.
it seems the...