Recent content by XxHaimBondxX

I think any 3 wire PAS sensor will work, you'll just have to re-pin it, which is a piece of cake.

JB Welding perhaps?

drill another hole and perhaps use a longer spoke.

Rear 1500 watt motor kit, 48-52 volt/20 amp battery should get you what you want, except the range. 25 mile range without pedaling is impossible imo for 20" fat tire with extra cargo weight, especially if you're riding constantly at 30 mph.

4. Extra weight 5. securing the battery Unless you invested in entire Ryobi collection, I would look for something more affordable. I use Greenworks 40v for everything and batteries are half the cost of Ryobi.

has different pinouts, you'd have to de-pin connectors and via trial and error figure it out.

I couldn't get any decent voltage reading anywhere, but I did buy a new battery. However, when wired I'm getting error 30, then computer shuts off, regardless if everything is connected or not. Seems like end of the road for this set up.

Actually I did try it on a 9v battery, which read 7.8 volts because it was pretty old. Meter is set to DC 200. There are no fuses in wires, I tested thick RED and BLACK wires, also at the battery cells as well. I will unwrap this battery tonight and attempt testing groups. Thanks for all your help.

Yeah I tried measuring everywhere, I even unsoldered bms to make sure it wasn't messing things up and still can't get a reading at main power wires, maximum it shows 1 volt. I found a local battery seller that will let me try it on the bike.

I may have completely messed up ordering a wrong bms and charger. When they list "14s", does that mean 14 white wires, black and red, in the connector? Mine has 13 white wires, red and black, total of 15, so is that 13s? Cells are Samsung 18650 26j. Also I'm not able to measure any voltage...

Thanks, I have a spare full throttle, but prefer a thumb throttle, so I may order one of those. However, for pas I'd rather make my connectors and cover up with electric tape.

Just got a Juiced Scorpion with missing throttle and ripped off PAS connector. Need to identify replacement or I could just match wires from another set and make my own connectors if replacement is cost prohibited? I don't want to order from Juiced website. Throttle connector from controller...

This completely makes sense for the juiced scorpion I just got, but doesn't for addmotor m-60 with 48v architecture and 14s bms. Was the battery actually 52volt? Why didn't they advertise as such? Which charger should have I gotten?

https://m.aliexpress.us/item/3256804486796896.html?spm=a2g0n.order_detail.order_detail_item.4.45b7f19comx5vw&gatewayAdapt=glo2usa&_randl_shipto=US

Here's where I am confused. Aren't all chargers put out more volts than they state on the label? For example, 48 volt chargers put out actual 54-58 volts. 58 volt = 64-68, etc. The 48 volt 14s charger I ordered would be putting out 58.8v per description. I used the 58v charger for a 5-10 second...