mi7d1
100 W
Problem with my c'lyte system is that I'm able to hold the wheel in my hand while applying full throttle. The motor pulls abit then I feel a jump and slip in the system.
motor 406
48v AGM SLA fully charged showing 51-51v on watts up meter
20a 36-72v immediate start controller
I'm fearing that my axle is slipping on the stator. I'm the one who did an axle swap with a front wheel motor. Is there anything else that could be causing the problem? Bad hall sensor? throttle? controller? The motor starts spinning the wheel every time I apply the throttle but there is so little torque that I can grasp the wheel and prevent it from turning. Any ideas? I need to do something by Friday May 16th. The e-Power Challenge is in ten days and my entry just took a dump. Where do I start?
kbarrett Are you in a position to sell your 405 if I need another motor?
motor 406
48v AGM SLA fully charged showing 51-51v on watts up meter
20a 36-72v immediate start controller
I'm fearing that my axle is slipping on the stator. I'm the one who did an axle swap with a front wheel motor. Is there anything else that could be causing the problem? Bad hall sensor? throttle? controller? The motor starts spinning the wheel every time I apply the throttle but there is so little torque that I can grasp the wheel and prevent it from turning. Any ideas? I need to do something by Friday May 16th. The e-Power Challenge is in ten days and my entry just took a dump. Where do I start?
kbarrett Are you in a position to sell your 405 if I need another motor?