Leebolectric
1 kW
I got a new HD unit for my lady, and everything mounted up great.
The wiring is all functional...rode smooth and powerful for a mile...made her smile so big!
...but after the first mile it started turning itself off....over and over.
When the bike is in the repair stand it runs fine...seems to be able to hold high speed for long periods without any issue when in the stand....seems perfect and normal...tried two different batteries with identical function.
...but when the bike is riden it turns itself of after about a minute or any load...in both PAS or Throttle modes.
...I tried shaking the bike to see if it was shorting while bouncing around...but it was fine.
The display turns off in less than a minute every time it is riden...then wont turn back on till the battery has been unplugged and replugged. (like a modem)
so in my best guess...it seems that when it is in the air on the stand, it uses very few watts/volts to push the wheel....but when it is under load and riden, the watts/volts peak much higher...which causes it to overload and turn off.
The batteries are 52v20a from Luna, and both work dandy on other bikes too.
I do not have the included E-brakes mounted because I read they were optional...and I prefer hydraulic nice brakes....is this part of the problem?
I will try the other display I bought...and other throttle I bought....don't know what else to try.
So...is there a voltage cutoff function that is activating to easily? or a setting that can be changed?
or...is the display/controller/something malfunctioning or defective?
or...am I a newb missing an obvious easier answer?
I hope this is enough info to get some help...not sure what to do here...thanks y'all.
The wiring is all functional...rode smooth and powerful for a mile...made her smile so big!
...but after the first mile it started turning itself off....over and over.
When the bike is in the repair stand it runs fine...seems to be able to hold high speed for long periods without any issue when in the stand....seems perfect and normal...tried two different batteries with identical function.
...but when the bike is riden it turns itself of after about a minute or any load...in both PAS or Throttle modes.
...I tried shaking the bike to see if it was shorting while bouncing around...but it was fine.
The display turns off in less than a minute every time it is riden...then wont turn back on till the battery has been unplugged and replugged. (like a modem)
so in my best guess...it seems that when it is in the air on the stand, it uses very few watts/volts to push the wheel....but when it is under load and riden, the watts/volts peak much higher...which causes it to overload and turn off.
The batteries are 52v20a from Luna, and both work dandy on other bikes too.
I do not have the included E-brakes mounted because I read they were optional...and I prefer hydraulic nice brakes....is this part of the problem?
I will try the other display I bought...and other throttle I bought....don't know what else to try.
So...is there a voltage cutoff function that is activating to easily? or a setting that can be changed?
or...is the display/controller/something malfunctioning or defective?
or...am I a newb missing an obvious easier answer?
I hope this is enough info to get some help...not sure what to do here...thanks y'all.