jacobthebluesman
🧲 New user
Hi,
As i understand it, when you swap out the torque sensor, it's going to need to be calibrated. Is that correct? If so, does anyone know how do do it on the M400 without BESST tool? I suppose it should be possible through something like Bafang Canable pro BUT when I tried it it didn't work. I suspected that the can message being sent from the SW is not correct for the M400. If so, does anyone know of the correct message for this model?
Any other insights into this is more than welcome!
As i understand it, when you swap out the torque sensor, it's going to need to be calibrated. Is that correct? If so, does anyone know how do do it on the M400 without BESST tool? I suppose it should be possible through something like Bafang Canable pro BUT when I tried it it didn't work. I suspected that the can message being sent from the SW is not correct for the M400. If so, does anyone know of the correct message for this model?
Any other insights into this is more than welcome!
Last edited:
