j bjork
1 MW
I am building a box for my lipo packs for the bike.
I have some questions, mainly how much pressure is good to have on them?
I hope that will lower the risk of puffing to mont them with some pressure.
This is what the box looks like:
I also think it would be good to drill holes to the sides of the cells, to release pressure if a cell vents?
Where the hand points:
Or is it enough to have the top open?
I plan to use this rubber under the cells, and possibly between packs and aluminum where i can fit it:
I will use the other, flat side against the packs. But if I put pressure on it, it will still not be even distributed over the cell surface. Do you think it will be ok, or do I have to find something without the ribs?
I have some questions, mainly how much pressure is good to have on them?
I hope that will lower the risk of puffing to mont them with some pressure.
This is what the box looks like:
I also think it would be good to drill holes to the sides of the cells, to release pressure if a cell vents?
Where the hand points:
Or is it enough to have the top open?
I plan to use this rubber under the cells, and possibly between packs and aluminum where i can fit it:
I will use the other, flat side against the packs. But if I put pressure on it, it will still not be even distributed over the cell surface. Do you think it will be ok, or do I have to find something without the ribs?