cboy
100 W
I am running two matching QS Motors hub wheels in a three wheeler. The controllers are both Kelly KLS7230S. From what I can gather here on ES, most folks running dual motors only use the sensor in one of the motors hooked to their Cycle Analyst 3. My concern is that the non-wired motor might, for some unforeseen reason, overheat and cause damage. Is it possible to either:
a) wire both temp sensors to the CA3 or
b) wire one motor temp sensor to the CA3 and the other motor temp sensor to its respective controller. The Kelly controller would then shut down power to the one wheel in an overheating situation and the CA3 would shut down power to BOTH wheels if it senses overheating in the wheel it is wired to.
a) wire both temp sensors to the CA3 or
b) wire one motor temp sensor to the CA3 and the other motor temp sensor to its respective controller. The Kelly controller would then shut down power to the one wheel in an overheating situation and the CA3 would shut down power to BOTH wheels if it senses overheating in the wheel it is wired to.