So I have an ebike in which the controller has 2 display output modes. 1 Phase Output. And 2 LCD Output.
When I connect to Phase output only the speed shows in display and the speed is basically how much throttle I give. And 2nd lcd output. In that the 3 speed mode indications, fault indications and all work and the speed is accurate and shows how fast the motor is spinning and not based on throttle output. I want arduino to read the lcd output and show in display. Any idea how I can do that?
When I connect to Phase output only the speed shows in display and the speed is basically how much throttle I give. And 2nd lcd output. In that the 3 speed mode indications, fault indications and all work and the speed is accurate and shows how fast the motor is spinning and not based on throttle output. I want arduino to read the lcd output and show in display. Any idea how I can do that?
