RebelPrinter
100 µW
- Joined
- Aug 6, 2022
- Messages
- 8
Hi guys. I just lucked into a Izip (250w). What I would like to do is add a second identical motor run off the same controller and throttle for 500w total power to get going or uphill, but put in a cut-off switch for one of the motor to extend range at cruise It's mostly flat around here).
So the questions are, what size controller should I be looking for to run both motors, and can I set the scond one up on the rear wheel as well (split sprocket instalation on the right side) or should that go front drive ideally ? Or possible even get one of these brackets and run both motors on the same chain Amazon.ca
So the questions are, what size controller should I be looking for to run both motors, and can I set the scond one up on the rear wheel as well (split sprocket instalation on the right side) or should that go front drive ideally ? Or possible even get one of these brackets and run both motors on the same chain Amazon.ca
Last edited: