jerrydubois3
100 mW
- Joined
- May 20, 2014
- Messages
- 39
Here is my Phasor Build. I do have to say that I have a Greyborg and a Raptor, plus about 4 other electric bikes along with a 2WD Yuba Mundo. This Phasor is a thing of beauty. I cannot say enough good about it. David designed a piece of E-Bike art! I did have to use a hydraulic cylinder to spread the swingarm a little to get the clearance for the CRO motor. I made a few spacers. Clamped the motor wires with a hose clamp covered with heatshrink...better than trusting a zip tie with 116volts at 100 amp! haven't turned it up past 25 amps yet...but it will do 30+ mph easy so far. Pretty light and nimble. like the thin frame. I mounted the Lyen controller to the top of the frame and used 2, 58 volt High Power cycle Batteries. The toggle switch is for series / parallel of the batteries.