Hi folks,
A mate recently purchased a new Bomber with the UFO hub motor, though it's not cranked up to 6.2KW.
It is a nice motor and the DC1 seems to manage heat reasonably well.
Question for Rix maybe; do they have a six turn version of this motor, give me torque over top speed?
I have just had to re-drill the flanges with new spoke holes further in at a smaller flange diameter.
They were pulling out because there was insufficient metal; about 1.2-1.4mm from hole to outsideof flange.
Has anyone else had the same experience yet?
I had the same problem with my MXUS hub on my bomber and successfully applied the same solution.
View attachment 1
Rix will vouch for this; MC rim on the back is the only way to go.
Awesome is a 17"x1.4" MC rim with a big 3.5" knobby or trials tyre on my bomber.
Tried 19" with tubliss-was OK but bigger tyre better. I still managed to pinch a 19" MC tyre occasionally.
Old Fighter well less than IP67 water proof.
Side covers off, battery out, maybe hall sensor plug separated to start.
You probably have water everywhere, including inside the controller; could maybe take the end plate off controller also to let it dry.
Cheers,
Clinton