Ebrake pinout - Higo connector - programming 600C display

[veloman]

I have a Grin superharness kit, but did not buy an ebrake. I want to program the 600C display. Which of the 4 pins on the ebrake connector do I short to replicate an ebrake signal? I tried all combos, except for shorting them all together. Anyone know?

 

[E-HP]

I tried all combos, except for shorting them all together. Anyone know?

Pins 1& 2 are for a digital (non variable) brake switch, per the manual. However, if you did try all combinations, including 1 to 4, chances are you fried the controllers 5v supply circuit.

 

[veloman]

Throttle and pas still work, so I guess I'm lucky. Where can I find a pin diagram? Tried looking around, just see the colors. Thanks

 

[veloman]

Found it