FLipsky Vesc 75100 Pro 2 Connects than throws firmware error

[Wubbena]

I have a version of the Flipsky Vesc 75100 Pro V2 and it was working great on the 300R2 firmware. For some reason I read we needed to drop it back to the 100R no restrictions. I thought I followed the directions but now I can't connect via bluetooth or USB. It says I can use a SW-Link which I have but there is no place to plug in the clk and dio cable.

I included a pic if anyone has any ideas i would appreciate it. I have read every forum, tried every thing possible but no dice.

 

[MNKY1234]

I've got the exact same issue.

 

[BiggKidd]

I was reading about this issue on their site yesterday. They said not to update from the 5.2 version or problems would occur. I'm looking to buy one of their 75 series soon.

 

[stancecoke]

there is no place to plug in the clk and dio cable.

The SWD interface is available directly on the PCB. As far as I can read from top to bottom
+3.3V
GND
SWDIO
SWCLK

Amazon.com