GREENTIME CONTROLLER PROBLEM

gzmann

10 mW
Joined
Apr 7, 2013
Messages
28
THANKS to anyone that can help me out
i bought a 48v 45a ccontroller from Leo

I hooked up a 48v battery/ throttle/ halls / phase wires and ensured the off/on switch wires were connected .
i get nothing???
i have a controller tester and it show no output from the phase wires????

Not sure what to do???

i have tried without hall wires, changed phase wires, changed to diff battery = nothing

anybody have similiar experience ??

i did not connect the CA wires - could this be the problem ?

my other 20a controllers work perfectly??


thanks for any help
 
Well i managed to figure it out!!

The order of the throttle wires for the greentime controller on the connector are not the same as the 3 throttle controllers that i own

i measured the throttle lines and ordered them appropriately ==== IT WORKED

http://www.electric-bikes.com/bikes/diag-03.html#controller
 
so the colours didnt match? red black green? im having the same problem too. i thought it was because i didnt connect the wire to the bike yellow and green single wires and the key igition wires
 
the yellow and signal wires had to be connected

the throttle i had had the wires differently arranged-- so i arranged the colours to match and it worked
 
Back
Top