Motor suspension?

[theprodigyp]

I would just go aluminum for your mounts. Those 3D Printed pieces won't be durable enough especially for a motor mount. Drive Wheel Adapters, you can get away with.

Planning on it, I think My first step is to redesign because I dont like the ATS mounts I am thinking I will get the vector ones to be safe and I was actually thinking of getting them milled in Delrin. If those dont work then I will go to aluminium.

I heard the vector trucks dot have a good turn radius. Just throwing out there.

Dang, well the ATS are hard to design around because of where the break bolt hole is placed. Are there any other trucks that I can use that would have a bolt hole through the center?

 

[BShady]

I think the matrix trucks are good for that but they are expansive