Hey guys . Basically what I'm looking for is some adjustability over my Mukuta 10+ controller.. I actually have it installed in a Vsett10+. I was always disappointed with the throttle curve on the rear motor when it's in single motor mode it's gutless. Basically the whole interface is terrible it runs like a hairy goat! to say the least. when it's in single motor mode you're lucky to get up a small hill and when you click it into duel motor you're literally breaking traction under power It's ridiculous.. I want my throttle power curve / ramp to raise ampage output a lot quicker that appears to be possibly speed based. So where I'm going with this is I'm familiar with scooter hacking firmware flashing devices and basic adjustability on programming but I'm going to need to do a bit of studying follow a few links to info that some of you fine people may share with me .time here so please go easier on me. I've been told that this controller runs lishui hardware and I should be able to flash it with a ST link v2 which I already have soon as I've been familiarising myself with scooter hacking firmware. and that it has the STM8 hopefully that's correct.. basically I want the parameters adjusted myself I'm just looking to raise that throttle current in a bit quicker... Can someone help me out that knows what they're talking about cuz obviously I don't
Last edited:
