Philosoraptor
1 W
- Joined
- Dec 7, 2021
- Messages
- 54
Finally pulled the old motors and Fesc off another project to start testing the remote control. Haven’t ordered batteries yet. I’m heading to the metal shop tomorrow to get some advice on the body and learn some tips on bending aluminum.
Here’s a picture of the current draft. The motor controllers are behind the motors, and the batteries are in the back (current estimates is two 20s2p packs of SPIM08HP) with BMS on top (Daly).
I intend to sink the controllers to the body, I might have them and batteries on some kind of standoff so if a rock bashes the bottom it doesn’t break the controller.
I’m debating what to segment off from what else. I want to manage heat and protect from water.
Sent from my iPhone using Tapatalk
Here’s a picture of the current draft. The motor controllers are behind the motors, and the batteries are in the back (current estimates is two 20s2p packs of SPIM08HP) with BMS on top (Daly).
I intend to sink the controllers to the body, I might have them and batteries on some kind of standoff so if a rock bashes the bottom it doesn’t break the controller.
I’m debating what to segment off from what else. I want to manage heat and protect from water.
Sent from my iPhone using Tapatalk