abecrizer
100 mW
Hello,
I accidentally figured something out. Perhaps it is obvious to others and everyone else on here knows this already,
but I want to share in case there is another noob out there this it may help.
I have a Cute q75 with a S06S and like using it on pedal assist (PAS). I had the LCD screen up on my handle bars, but
would prefer it not be there. I don't use anything on there anyway, and I have enough clutter on the bike.
I assumed I needed it plugged in to get the system to work. The wiring diagram for the controller says
"P.S. On condition there is no LCD controller will work by shorting 1,2 & 3,5" (see attached picture)
I assumed this would only allow the throttle to work but not the PAS.
One day the LCD stopped working. I don't know why. I took the whole thing apart and shorted as above, and the PAS worked anyway.
This is significant because on the Q75 if I put the assist level to 5 on hills the motor gets too many Watts, a terrible grinding noise comes out
and the whole thing grinds to a halt. So I used it on #4 and all is well. Even after jumping the pins and unplugging the LCD,
Some one the controller has that 4 in his memory even without the LCD plugged in at all because it the motor does not have that grinding problem.
Interestingly, I plugged the LCD back in later and it worked again, even with the jumpers in place, so I don't know why that happened
but I am glad it did so I get one thing of the bars.
I hope what is above makes a little sense.
I accidentally figured something out. Perhaps it is obvious to others and everyone else on here knows this already,
but I want to share in case there is another noob out there this it may help.
I have a Cute q75 with a S06S and like using it on pedal assist (PAS). I had the LCD screen up on my handle bars, but
would prefer it not be there. I don't use anything on there anyway, and I have enough clutter on the bike.
I assumed I needed it plugged in to get the system to work. The wiring diagram for the controller says
"P.S. On condition there is no LCD controller will work by shorting 1,2 & 3,5" (see attached picture)
I assumed this would only allow the throttle to work but not the PAS.
One day the LCD stopped working. I don't know why. I took the whole thing apart and shorted as above, and the PAS worked anyway.
This is significant because on the Q75 if I put the assist level to 5 on hills the motor gets too many Watts, a terrible grinding noise comes out
and the whole thing grinds to a halt. So I used it on #4 and all is well. Even after jumping the pins and unplugging the LCD,
Some one the controller has that 4 in his memory even without the LCD plugged in at all because it the motor does not have that grinding problem.
Interestingly, I plugged the LCD back in later and it worked again, even with the jumpers in place, so I don't know why that happened
but I am glad it did so I get one thing of the bars.
I hope what is above makes a little sense.