Bobby.T
10 mW
- Joined
- Mar 28, 2021
- Messages
- 21
Hi guys 1st time posting but been lurking for a while. I have a sabvoton 96120 arriving tomorrow and have a good grasp of what settings I want to run and how to wire it up. However 1 portion of the instructions does confuse me
"if 3 speed (switch) mode selected,
Connect the pink and ground wire. Enter high speed mode
Connect the transparent and ground wire. Enter low speed mode
Disconnect pink ,transparent wire and ground ,enter middle speed mode"
I will be running the 3 speed switch, the bike is an emmo Kamen with a 30ah 22s 100amp bms+qs260 v4 6000w motor.
I know the bike has the 3 wires for the 3 speed all ready and the controller should have 3 wires as well, why can't I just plug and play? The instructions make it sound like I need to do the 3 speed wires in an odd sequence.
"if 3 speed (switch) mode selected,
Connect the pink and ground wire. Enter high speed mode
Connect the transparent and ground wire. Enter low speed mode
Disconnect pink ,transparent wire and ground ,enter middle speed mode"
I will be running the 3 speed switch, the bike is an emmo Kamen with a 30ah 22s 100amp bms+qs260 v4 6000w motor.
I know the bike has the 3 wires for the 3 speed all ready and the controller should have 3 wires as well, why can't I just plug and play? The instructions make it sound like I need to do the 3 speed wires in an odd sequence.