j bjork
1 MW
On my new build I will run the new QS 180 90h mid drive IPM motor.
The problem is to find any good, powerful controller and then fit it on the bike..
So I am considering splitting the motor phases by mesuring strand by strand in to 6 equal phases and run dual controllers.
The strands will then be paralell on the same tooths, but electrical isolated from each other.
Would there be potential problems? Like the magnetic fields interfearing with each other and things like that.
I havent decided on controllers, but I am looking at BESC g2, the new Powervelocity vesc based, nucular 24fet etc.
The problem is to find any good, powerful controller and then fit it on the bike..
So I am considering splitting the motor phases by mesuring strand by strand in to 6 equal phases and run dual controllers.
The strands will then be paralell on the same tooths, but electrical isolated from each other.
Would there be potential problems? Like the magnetic fields interfearing with each other and things like that.
I havent decided on controllers, but I am looking at BESC g2, the new Powervelocity vesc based, nucular 24fet etc.