Sw900 p14 realted to controller

[Cyclomania]

So on one of the bikes I have my controller is as the picture 35+- which is a good powerful controller. Battery is 48 motor is 1000w.

Now, on the sw900-display on the bike there is a p14 setting, in the parameters, that is "the current-limiting of controller".

This is now set to 20. But as I understand it, since I have a rather powerful controller I could set this setting up to maybe something like 30-35? Or am I thinking correctly here?

thanks

 

[lnanek]

Depends on the attached battery's BMS max discharge setting. Too high and the battery will cut off discharge on you. Similarly, pulling high amps can cause heating in the controller and any thin wires and connectors, so you'd have to check temperatures.

 

[E-HP]

This is now set to 20. But as I understand it, since I have a rather powerful controller I could set this setting up to maybe something like 30-35? Or am I thinking correctly here?

thanks

This depends on your battery specs, not your controller.