TSDZ2 New Install, No Power/Assist To Motor (OSF v20.1C.4)

[tcbarton]

I'm new to the TSDZ2 and OSF so I hoping this issue is something a noob overlooks configuration. I have a TSDZ2 36v/350w and 860C running on OSF v20.1C.4. The display seems to work correctly when I ride except that I have no power/assist. I've tried all modes (power asiset, torque assist, etc.) and all assist levels from 1 to 9.

When riding the bike it properly displays speed, human power input, and cadence (technical menu), but all the motor and battery power metrics show zero. The controller isn't providing any power to the motor.

Any suggestions or help would be greatly appreciated at this point as I've reached my wit's end. I've got a nice 30lb road ebike ready to go, but no-joy .

Todd B.

 

[tcbarton]

Well...I finally figure it out after going through the config menus for the hundredth time. Defaults were set for 48v motor and I didn't find/reset the low-cutoff lower for a 36v battery.

Sorry for the nuisance post.

Here is the bike build...



Todd B.