alex jones
100 mW
- Joined
- May 16, 2016
- Messages
- 35
I have a mini remote hand controller. When I switch the hand controller off the VESC lights up and starts turning the motor. :? all by itself.
Just wanted to know what I'm doing wrong as this surely can't be right.
While I'm here the sensitivity of the trigger is so fine with accelertion and braking everytime I squeeze the trigger more than say 2mm the VESC stops and reboots. Just wanted to know if there was a soft start feature and the ability to use the whole of the trigger rather than just the first 2mm? I want to be able to squeeze the trigger quickly full on and not "trip" the VESC.
All of the above while the vesc is connected to a 12v power source on my kitchen table.
Just wanted to know what I'm doing wrong as this surely can't be right.
While I'm here the sensitivity of the trigger is so fine with accelertion and braking everytime I squeeze the trigger more than say 2mm the VESC stops and reboots. Just wanted to know if there was a soft start feature and the ability to use the whole of the trigger rather than just the first 2mm? I want to be able to squeeze the trigger quickly full on and not "trip" the VESC.
All of the above while the vesc is connected to a 12v power source on my kitchen table.