Search results

Date Relevance Most replies

  1. A

    Installing Power Button on Contoller

    My eZee controller doesn't have an on/off switch so I get a "pop" when I connect my battery. It doesn't seem like this is good for the connectors. The metal inside the Andersons is getting charred. I assume since the Infineons have a power switch this is a desirable feature. I was thinking an...
  2. A

    What does this hub noise indicate? (video)

    When my motor is under a lot of strain I get the noise in the video below accompanied by what I can best describe as motor power "pulsing" rather than a steady pull. If I back off the throttle the motor smooths out. Happens on flats and hill. Setup is eZee front hub in a large diameter front...
  3. A

    "MaxAmps" Setting in CA

    I wasn't sure about this when setting up my CA and left it at the default 50A setting. My battery amp specs are: Rated Discharging Amperage: 20 Amps Max Continuous Discharging Amperage: 40 Amps Maximum Discharging Current: 60 Amps Discharging Cut-off Protection: 40-50 Amps How does the...
  4. A

    50 miles on first build . . . think I need advice on second

    After doing a couple of short shakedown rides I took the half-fat e-dummy on a couple long, hilly rides today. I was very curious how much juice it would take to get both kids back from my sister in law's, a 17 mile route with 1,134 ft. of elevation gain. The battery (36V 20Ah Ping) went...
  5. A

    Domestic Source for JST Pins and Housing?

    Wiring up my first build today and one of the hall sensor wires pulled out on the 5 pin JST housing. I pulled out the pin but I'm not sure I can reuse it. And I figured if I need to get another pin. I've found what I need on ebay-- http://tinyurl.com/mpntfmx But it would be nice not to have...
  6. A

    Brick & Mortar Anderson Source? Or, Suitable Replacement?

    I have all the parts for my first build beside a battery case and Anderson connectors to attach my Ping battery to my controller. About head to the store to pick up pars to build a case and get connectors, but . . . To my surprise I come up empty searching the Radio Shack and Home Depot...
  7. A

    Best Practices: Caring for Ping Battery

    I'm about to do my first build and the last part I'm waiting for is my battery. I chose a 36V 20Ah from Ping and chose the 5A charger. I've never spent so much money on a battery in my life, and I'm keen to care for it as well as possible. Are the included BMS and charger adequate? Are there...
  8. A

    First Build: Big, Half-Fat E-Dummy

    I'm anxiously awaiting parts for this build. I have a Big Dummy that I use to carry my children. Before moving to the country I was able to get almost exclusively on bike or foot, but now I'm in hilly New Hampshire in a tiny town and the nearest grocery store is about 13 miles away. I'm...
  9. A

    High Rate BMS from Ping, do I need it?

    Planning to put eZee hub on cargo bike and ordering a 36V 15A battery from Ping. I am not sure if my needs require the high rate BMS option. Bicycle will sometimes be heavy (as much as 440 pounds) I have one steep hill to climb (2 miles avg. 4%). I am not looking to go fast. I've been...
Back
Top