Skalabala
1 kW
Anyone tried to go on Alibaba and have a look on Greentime controllers lately?
Can not find any! Or maybe I did something wrong with the search :?
Can not find any! Or maybe I did something wrong with the search :?
stevc said:http://www.aliexpress.com/item/24FET-IRFB4110-s-3000W-48-84V-80Amax-BLDC-motor-controller-EV-brushless-speed-controller-sensor-sensorless/522263950.html
I have had an order in for a while (2nd of June) Hopefully it shows up soon.
Skalabala said:Anyone tried to go on Alibaba and have a look on Greentime controllers lately?
Can not find any! Or maybe I did something wrong with the search :?
jansevr said:i was running sensored initially but burnt the windings on one of my hs3540s
jansevr said:i was running sensored initially but burnt the windings on one of my hs3540s
ebike11 said:Hi guys
I have a 72v 1500w Greentime
There is a 6 colored wired JST plug which looks the exact same as on the Infineon controller and Cycle Analyst
wires. Has anyone tried plugging a CA in a Greentime controller??
Thx
Kent said:ebike11 said:Hi guys
I have a 72v 1500w Greentime
There is a 6 colored wired JST plug which looks the exact same as on the Infineon controller and Cycle Analyst
wires. Has anyone tried plugging a CA in a Greentime controller??
Thx
Yes that sounds like it. I had to ask Leo to install the CA wires/plug on my 24 fet.
However, when plugged in it only showed voltage-nothing else. I e-mailed Leo about it but am not holding my breath....
There is discussion about this earlier on in this thread, but I don't recall where.
evolutiongts said:Kent said:ebike11 said:Hi guys
I have a 72v 1500w Greentime
There is a 6 colored wired JST plug which looks the exact same as on the Infineon controller and Cycle Analyst
wires. Has anyone tried plugging a CA in a Greentime controller??
Thx
Yes that sounds like it. I had to ask Leo to install the CA wires/plug on my 24 fet.
However, when plugged in it only showed voltage-nothing else. I e-mailed Leo about it but am not holding my breath....
There is discussion about this earlier on in this thread, but I don't recall where.
You need to modify the controller. Swap the Green Throttle cable to the CA 6-pin on the controller.
agniusm said:Does anyone knows what currents are involved at ignition wire and 3 speed switch? Need to pick correct relays. Thanks