Hi ESFMs,
A while back, I was swapping out a motor into a newly laced wheel. While I was tightening the bolts on the covering plates, I made the mistake of applying too much tension on one of the bolts and broke off the head.
How do I go about taking this bolt out so I can replace it with a new one? I tried the Dremel hack so I can unscrew with a Flathead but it's cutting a groove into the surrounding and I don't want to compromise the seal.
I'll provide a pic soon.
A while back, I was swapping out a motor into a newly laced wheel. While I was tightening the bolts on the covering plates, I made the mistake of applying too much tension on one of the bolts and broke off the head.
How do I go about taking this bolt out so I can replace it with a new one? I tried the Dremel hack so I can unscrew with a Flathead but it's cutting a groove into the surrounding and I don't want to compromise the seal.
I'll provide a pic soon.