RadRover ST 1 wiring pinout

[jayqsen]

I disassembled the oem display as it had failed and used a continuity tester to get these results. Hopefully this will help others when troubleshooting Radrovers and maybe other Radpower bikes.

 

[E-HP]

I was looking at the various RAD connectors when looking at another thread recently. Seems they used the screw on connectors for the bikes using Lishui controllers, then went to julet 5 pins for the newer ones using ASI controllers.

 

[jayqsen]

I was looking at the various RAD connectors when looking at another thread recently. Seems they used the screw on connectors for the bikes using Lishui controllers, then went to julet 5 pins for the newer ones using ASI controllers.

Interesting......this bike is from 2021.....I wonder when they switched.

 

[E-HP]

Interesting......this bike is from 2021.....I wonder when they switched.

Must be recent. The article showed Rad Rover 1 to 5 with the screw on, and 6 using the Julet.

 

[jayqsen]

I did more wire tracing and found a way to bypass the display.

 

[E-HP]

Or instead of a jumper, you can use an on/off toggle switch to turn the controller on and off, too.

Thanks for posting this thread. It’s a good place to put/share the Rad stuff.

 

[jayqsen]

I like the idea of a switch

 

[E-HP]

I like the idea of a switch

If you decide to do that, try to post some pics of how you did it, to help the next person that’s looking to run without a display.