afzal

Yes, ST-Link converted to J-Link is for STM targets, I did not properly check TSDZ8 processor earlier. Upon checking my earlier notes...

Thanks for the offer. I’ll keep it in mind if my order gets screwed up for some reason.

@E-HP , ST-Link on-board ST development board's can be converted to Segger J-Link as mentioned here. Possible ST development boards are...

Thanks! added. I can't believe I started this 4 years ago. Doesn't feel that long, since I just make it a habit of adding new things...

Seems something specific to your browser got prefixed to the actual in the hyperlink for LCD6

I think I've read through all of the stickies in the ebike forums, which provide great guidance. Yet, I see a lot a new folks getting...

Once you are back from the time machine, a suggestion, + LCD6, http://www.szktdz.com/upload/file/20230921/20230921084052_35337.pdf

I"m glad your bike is still hanging in there as well as you. finally read up your accident (thought mine was bad) Need to drag out my...

So my bike was in my garage while my house burned. I'll answer the immediate questions I'm sure that statement brought to mind. No one...

That's a Xenforo design feature. Some of these signatures would make pages 33-50% longer on mobile, requiting a ton more scrolling. I...

+1 Seems this is a Xenforo issue, the same problem is observed on another forum using Xenforo. In the mobile browser (Firefox...

Sim card tray ejector tool is perhaps better suited than paper clip. Make sure to insert it on the opposite side of square hole as...

Offroad 05-15-25 Road 05-16-25 I've been trying to get motivated to fix my ebike, but every time I look at it and see broken parts...

If throttle signal & ground is accessible, connecting a pull down resistor (say 10K) between them perhaps will help

https://endless-sphere.com/robots.txt wikipedia article on it: https://en.wikipedia.org/wiki/Robots.txt It's a set of rules for what...