Recent content by Golo

There is a newer dyname 4.0 too and I think that one is even better noise wise if I'm not wrong. These bikes use a standard race face bottom bracket that I think I will use on my bike if the bikee bottom bracket wears out.

This is the only picture I have right now. I have made the battery myself, and I'm not finished yet. I have ordered a small top tube bag I hope to be able to put it in. I will also try to route the cable for the display and trottle inside the frame I just wanted to be able to ride it 😅

I ordered my kit June 2022 and got it last week.

I have not noticed any crank wobble yet, I have the isis splined crank. I can ask if there is a more silent revision and if mine is one of them. It makes noise, a bbshd is definitely quieter. But it doesn't irritate me like the cyc stealth did. In about 20kmh (12,5mph) I hear only wind and at...

I have now innstalled my 1000w high torque kit on my bike. I am quite impressed of this motor so far. It is very pulls very strongly and the torque sensing is very nice too. I have not ridden it very much yet but I really like it. The noise level is not bad, and the pitch doesn't annoy me. It's...

I am thinking of going with the freewheel from a Rocky mountain powerplay if the bikee turns out to not work well for me. https://www.pro-mstore.com/en/rocky-mountain-spider-clutch-race-face-for-powerplay-10670655 It is for the RaceFace Cinch crank system. This parts is available for purchase...

I also think that the low weight will be great. I am going to add about 4kgs(8,8 pounds) to my bike, with the motor and the battery combined. I'm building 2 52v 520wh batteries, so I can bring a spare on long trips. The total weight of my full suspension 29er will be under 20 kgs. That's great...

Maybe adding some rubber between the frame and the motor and put it under a bit of pressure could reduce the noise. I will try that on mine. https://www.facebook.com/groups/1783088068776745/permalink/1899100623842155/ Watching this video on the owners group, and to me it sounds like this one...

Here is me riding the X1 stealth as a comparison.

Thank you @nervagon it seems to be less noisy than my x1 stealth gen 1, but maybe not as silent as I hoped for. I am running that one in LDS mode which combines torque sensing and pas. It runs smoother than this one does. I have had very much tweaking with the settings on that one before i was...

Sad to that the noise is bad :confused:And the other issuses as well. It would nice if you could post a little riding video of it, as it is very few of them. And they seems to have very different sound the few of them i have seen. The last one on the owners group on facebook didnt sound too...

I have been looking around for different solutions for the bottombracket and cranks. And this freewheel for the Rocky Mountain Powerplay might work. It is based on the Raceface cinch Bottom brackets and cranks. If it turns out i really like this motor and if get problems with the Bikeebike...

It would have been interesting if you made a video of the bbshd bike in the same way you did with the lighest. As a comparison since the bbshd is known for beeing very silent.

I'm really looking forvard to a test ride video to get a better impression of the noise. I might have found a solution for the isis bottom bracket for my bike. I hope this axle can be used. If if understand right it gives me isis spline with my existing shimano hollowtech BB...

I dont know for sure that it is quiet, after seeing the very few movies that is about it, it seems atleast a good bit more silent than the x1 stealth. So this is what i am most exited to find out about it. It felt like i took a chance by ordering it last year.