Recent content by phomann

Hi, I have no issue shipping overseas if you are after a ready made board. http://www.homanndesigns.com/store/index.php?main_page=product_info&cPath=51&products_id=278 Cheers, Peter

Hi, I could probably make some up on my small CNC mill. Can any one send me an accurate drawing of the dimensions? Cheers, Peter

Hey Guys, Just a quick note. For those that have been emailing, the MiniWiicever is now back in stock. If you need a Nyko remote, you can bundle that with the MiniWiicever. http://www.homanndesigns.com/store/index.php?main_page=index&cPath=51 Cheers, Peter

I would expect that the NRF24L01+ would be a better solution than Bluetooth. The control required is relatively basic and in my opinion doesn't warrant the complexity and cost of Bluetooth. Cheers, Peter

The data sheet says 7.5A. Yes, that would be per pin. http://media.digikey.com/pdf/Data%20Sheets/ITT%20PDFs/DE9P.pdf But as you know, in the end I used one of you pre-built charging cables. Life is too short to be soldering cable connectors. :) Cheers, Peter

Hi, A quality 9 pin D-sub connector such as this one is rated for 7.5 Amps, more than enough for most chargers. http://www.digikey.com/product-detail/en/DE9P/IDE9P-ND/2580862 Cheers, Peter

Thanks for that, it looks like just the ticket. Cheers, Peter

Hey Psychotiller, Where did you get this deck from. I'm looking at doing a all terrain board and this deck looks ideal? Cheers, Peter

I'll take a pair as well. Cheers, Peter

Hey Benj, Great to hear. :D Cheers, Peter

Another batch of boards fresh out of the pick and place machine, ready to be programmed and tested. This batch is all taken. Cheers, Peter

Hi All, Well, the longboard is finally done for now. I have a list of improvements that I would do if I was to build another board. I leant a great deal along the way. Thanks for all the help from everyone who chimed in. The board is running Homebuilt maple veener deck Calibre 50 trucks ABEC...

It looks like they succeeded in silencing you after all. Cheers, Peter

Hi Sebastien, The best way to work out the belt length is use this calculator. https://sdp-si.com/eStore/CenterDistanceDesigner According to it the diameter of a 64 tooth 5mm HTD pulley is 101.86mm (4.0102") Cheers, Peter

I think I need a set of these. :) Cheers, Peter