Search results

Date Relevance Most replies

  1. D

    Strong freewheeling crankset

    I ordered one from Paco 2 weeks ago. Delivery quoted for 30th May and cost 198 USD delivered to uk DaveP
  2. D

    Strong freewheeling crankset

    I have fitted the adjustable sheets and realised the clearances with the crank rotating were a bit fine so I have also removed the "3 spacer washers" by cutting the threads a bit longer ( I also replaced the bolts with stainless steel ones to ensure that I can easily adjust them in future). I...
  3. D

    Strong freewheeling crankset

    Can you post any photos of the changes you made. I have a set of Lightning Rods adjustable plates and I am considering fitting a cyclone crankset. Thanks DaveP
  4. D

    GNG, 1000W 48V BB-drive, $400

    It's difficult to keep everything tight and square at the same time while the bolts are tightened. I cut 2 hardwood wedges (about 30 degrees or so) and used one each side between ends of the motor casing and the metal housing for the jack shaft bearings. Don't tap them in too tight just enough...
  5. D

    GNG, 1000W 48V BB-drive, $400

    In the process of fitting the adjustable sheets I removed the freewheel on the jackshaft. Even though new it did not run very smoothly so in view of the problems encountered by skyunjiae and others I decided to risk taking it apart and loosing the ball bearings. Interestingly the races are not...
  6. D

    GNG, 1000W 48V BB-drive, $400

    I have recently obtained a gng kit and a set of adjustable sheets from LightningRods. I will start to fit it to the bike after Easter when I have some time and use the bike through the summer. In the autumn I wish to change both the primary and secondary drive to give me a lower cadence, aiming...
  7. D

    GNG, 1000W 48V BB-drive, $400

    I would like to echo the sentiments from bzwindtalker. A couple of years ago I built a front hub e bike which was not very good. My lack of knowledge, experience etc led me to put it in the garage and buy a Vectrix - which is fun. I don't want to go at high speed all the time, I just want to...
  8. D

    GNG, 1000W 48V BB-drive, $400

    What I Want I want to build an e-bike for fun and have been reading this an other threads on endlesss sphere for a while. A GNG mid drive seems to suit my requirements best? Tried a front hub motor a couple of years ago but did not like the balance. Therefore mid drive preferable to hub motor...
Back
Top