kingkongshrimp
10 W
- Joined
- Nov 2, 2021
- Messages
- 72
Had to drill new holes for the bushing housing because the previous hole were too big. I wasn't comfortable welding together such big gap. The new holes are more snug, i'm good with that.
Using the plate out of the hole, i made an insert. This insert should keep the housing from warping too much when welding to the arm.
Spot welded it to keep it in place.
Not winning that International Welding Award but my best friend Angle Grinder will help make it pretty later.
Using the plate out of the hole, i made an insert. This insert should keep the housing from warping too much when welding to the arm.
Spot welded it to keep it in place.
Not winning that International Welding Award but my best friend Angle Grinder will help make it pretty later.