I received my motor today. Looks like I can make it work, they installed some jenky freewheel that I have to figure out to remove. Freewheel is a total pos and has lots of slop and what feels like maybe 10 pawls. They also included a 160mm disc brake and a mechanical caliper. Frot hub included as well, but it's not quick release. Caliper and hub will probably go in the bin.
The motor appears usable but the wiring is exiting on the axle flat which is going to make it interesting to Mount without destroying it. I have some pictures which I will post tomorrow. Phase wiring is thin, much smaller than the Cromotor. I have a comparison picture.
Lacing is radial, bit of a disappointment there. It does have dual Hall sensors which is a nice extra.
Motor flange is 50mm wide. Cover to cover is 86mm. For comparison the Cromotor is 100mm cover to cover.
I will try to open up the motor and get some measurements this weekend. This is not even close to the level of a Cromotor. If it is a high speed wind I will probably have to upgrade the phase wires to handle the current.