BMS identification

[wallypedal]

This BMS came from an aluminum cased lifepo4 36v10ah setup. I would like to know what it is, if it is appropriate for the setup, etc. It is much smaller than my older signalab, but a signalab would not have fit in this case. Wanting to test it and try it again if it isn't junk.

 

[dmwahl]

Maybe someone will recognize it, but the photo is too blurry to be of much use. What is that big IC in the center? Any markings you can read?

 

[wallypedal]

Funny the photo got so blurry, we'll work on that. It isn't so bad on my PC.The IC and both sides of the board have some sort of finish coating brushed on. It filled the numbers on the IC where I can't read them with my magnifying equipment. I'll try to get a better pic. Thanks!
Wallypedal

 

[dmwahl]

That's conformal coating, for protection against water, dust, etc. Paint thinner on a q-tip may take it off, depending on the specific type.

 

[wallypedal]

new pictures