Cycle Analyst High Amp reading and AH counting

[Simple818]

I just got finished programming my Lyen 12 fet and took it for a ride down the block. I hit full throttle on the way down hill and all of a sudden the motor cut out. I look down and see that my CA 2.4 is reading 185.3 amps and my Ah is still rising even though the bike is standing still. I then unplug the CA and the bike seems to run fine. I have tried unplugging and resetting the CA but have had no luck. Any suggestions are welcome

 

[amberwolf]

If it's not actually drawing that current (stuff would be awfuly warm if it was ), then there's a loose connection or bad contact at a pin somewhere from the CA itself to the solder connection at the shunt (etiher inside teh controller or the external one, whichever you have).

 

[Simple818]

Was a loose connection at the shunt. The white wire off the Cycle analysyt. I soldered all the connections on so my it's my fault.