vipertriplex
10 mW
- Joined
- Jul 3, 2016
- Messages
- 28
Hi Guys,
Been working on a dual motor project bike over the winter incorporating a front 3k motor and a rear 5k motor. Both being powered by 2 linked Adaptto controllers Mid-Max. The build worked out great and now its battery time.
I intend to run this setup in 32s utilizing Samsung 40T 21700 cells to max both controllers. As this is my first dually Im not really sure which way to go that would be more efficient. A single 150A pack, a 300a pack or 2 smaller 150A packs.
The most obvious being the two separate packs and that would workout fine if both motors were running continuously full time. This is not the case in this application as the front motor is only used to get the bike up to 35mph, then all power is diverted to the rear controller to run the rear motor only.
Which would you believe to be the best coarse of action?
And thanks in advance
Been working on a dual motor project bike over the winter incorporating a front 3k motor and a rear 5k motor. Both being powered by 2 linked Adaptto controllers Mid-Max. The build worked out great and now its battery time.
I intend to run this setup in 32s utilizing Samsung 40T 21700 cells to max both controllers. As this is my first dually Im not really sure which way to go that would be more efficient. A single 150A pack, a 300a pack or 2 smaller 150A packs.
The most obvious being the two separate packs and that would workout fine if both motors were running continuously full time. This is not the case in this application as the front motor is only used to get the bike up to 35mph, then all power is diverted to the rear controller to run the rear motor only.
Which would you believe to be the best coarse of action?
And thanks in advance