multifrag
100 W
Brought back from the dead an old project of mine. Rewired all the cables and powered it up. Surprise, surprise it does not work as expected. Does not want to start from standstill and when given a push it only works for an instant before the throttle gets unresponsive and I have to reset the throttle position. Could it be the hall effect sensors or there is something with the hub?
https://www.youtube.com/watch?v=N2XRXkqosgE
Edit:
The screen is saying that something is wrong with the hub. I've checked the hall wires for continuity, gonna check if phase wires are intact...
Edit 2:
One of the Hall sensors GND is in short circuit with signal wire...
The waterproof 5 pin connector has 2 pins in short circuit...
https://www.youtube.com/watch?v=N2XRXkqosgE
Edit:
The screen is saying that something is wrong with the hub. I've checked the hall wires for continuity, gonna check if phase wires are intact...
Edit 2:
One of the Hall sensors GND is in short circuit with signal wire...
The waterproof 5 pin connector has 2 pins in short circuit...