ixandstones
10 mW
bowhunter29 said:The two braces that the drive sits against were out of square and too wide so the bottom plate of the drive couldn't sit flat against the mounting plate on the bike frame. I gently bent them inboard and the drive slid right into place. From there it was a matter of marking the mounting holes, drilling them, and bolting the drive in.
Hello, I think I have the same problem. My LR drive will not fit into the luna frame. If I put the plastic bits in that attache to the seatpost, the motor will not be flush against the bottom. If it is flush against the bottom, it wont line up properly with the seatpost or be in a stright line as the drive chain will be. When I measured the circular supports on the rear, they are not symmetrical as you say. One side is 1/8 of an inch more inwards (toward the seatpost). How do I bend these (thick steel pipes) without bending the whole frame out of whack?