grandpeddler420
100 µW
- Joined
- Sep 28, 2021
- Messages
- 8
I have a Emad 36v 800w electric skateboard. The original board was missing from it when I bought it. So after some trials and tribulations. I found a controller that seemed to work pretty flawlessly. Until it didn't. I put 50 to 70 miles on it then something popped on it.
So I ordered another board. This one was different from all the others. No relay. Even if the controller didn't have reverse option. There was always at least 1 relay. Why is that? What is this controller using in place of relay? Is this better or worse? Because now my motor is overheating to the point of softening the paint on motor. Could this setup be what is causing that? Any info or tips with this would be greatly appreciated. Thank you in advance.
My board is simple.
3x 12v 22ah AMG in series
Motor Controller, DROK PWM DC... https://www.amazon.com/dp/B07B4B2X35?ref=ppx_pop_mob_ap_share
800w brushed
So I ordered another board. This one was different from all the others. No relay. Even if the controller didn't have reverse option. There was always at least 1 relay. Why is that? What is this controller using in place of relay? Is this better or worse? Because now my motor is overheating to the point of softening the paint on motor. Could this setup be what is causing that? Any info or tips with this would be greatly appreciated. Thank you in advance.
My board is simple.
3x 12v 22ah AMG in series
Motor Controller, DROK PWM DC... https://www.amazon.com/dp/B07B4B2X35?ref=ppx_pop_mob_ap_share
800w brushed