No power to G062 1000w hub on an ABLE A7 ebike

[Tazman]

I have power on, display(C961)works fine, no errors, p.a.s changes 1 to 5 on display, freewheel MPH shows when peddling or by hand, even changed the p.a.s wire etc, all conectors checked, battery(52v)is full and working,gʻ no signs of wear on the Bafang motor cable. Checked brakes for sticking. Was just peddling along at 20mph then just no throttle or P.A.S anymore.
Could this be an issue with the controller, if so i then do i just change the controller.

Any help please guys.

 

[Tazman]

If checked the motor plug coming out from the controller that would hopefully tell me if no voltage its the controller that is a brick, but which holes do i test for voltage as i do not want a shock or fry something??. Thanks

 

[Papa]

 

[Tazman]

Thank you Papa. Can you add any comments to my previous posts on my controller problem?

 

[Tazman]

What do i test first after i have BLACK (gnd)??

 

[Papa]

Troubleshooting - Getting Advanced - Resources

One of the things about meshing complex electrical and mechanical systems together is that occasionally things can go wrong! We've seen more than our fair share of ebike issues come and go over the years - from shot ball bearings, seized freewheels and stripped threads to defective hall sensors...

ebikes.ca

 

[Tazman]

Thank you for the info, but my L1019 us not bare wires its an actual plug.

 

[Tazman]

Phase yellow to blue is 38.8 ohms
Phase green to blue is 38.8 ohms
Phase yellow to green is 38.8 ohms
Hall yellow is 3.33v
Hall green is 3.33v
Hall blue is 3.33v
Grey what ever that is 0v
Red 5v is 5v
White speed is 3.2v
These are my results from testing the L1019 plug from the controller to the hub.
I think but not sure if its the the hub that is bricked. Whats your comments please guys

 

[Tazman]

Messed up. 3× Phase wires (yellow, green and blue) reading is 0.4 sometimes 0.5